Bathrooms are tiled

1. Before tile paving, standardize the acceptance and reasonable protection of the waterproof layer and water circuit transformation to prevent damage to the tile during construction; >>>More

Bathroom tiles should be laid to the height of the ceiling, and the ceiling should not be lower than meters.

Dry paving method, which is divided into slurry and scraping paving. A slurry paving method refers to the cement of 1: evenly mixed with sand, the water added is not much, after stirring, it can be kneaded into a ball by hand (can not pinch out the water), and the excess water is sucked out of the structural layer with cement powder evenly sprinkled on the structural layer after cleaning and washing, forming cement slurry, and then the cement slurry is brushed evenly with a wire brush (this process is very important, otherwise the mortar is not sticky to the bottom. >>>More

There are three ways to deal with it:

1. The most economical thing is to brush epoxy resin paint on the premise that the base surface is a flat concrete base surface (that is, the cement surface is smoothed), and you can brush it yourself. Painters have zero foundation, you can buy a small roller to roll slowly, buy domestic, generally more than 100 a bucket, an ordinary bathroom can be brushed again, don't worry, buy a bucket to brush again. There are a variety of colors to choose from, and colorless ones can also be selected, but to look good, the original concrete base surface must be made very flat and flowerless, so if you want a clear water effect, I generally recommend directly choosing the appropriate gray. >>>More

First, choose tiles with low water absorption, generally speaking, high-quality tiles have very low water absorption, so that they can dry quickly. If the tile does not indicate the water absorption, you can use tea or water droplets on the back of the tile, and check the diffusion degree of the water droplets after a few minutes. Tiles with high water absorption rate will be cracked on the surface of the tiles and peeling off the entire wall and floor tiles after thermal expansion and contraction. >>>More