The bathroom floor is rough and not smooth, can it be waterproof?

In the home decoration, the general bathroom waterproofing must be considered to do, even if it has been done when buying a house, but if the pipeline or partition wall is altered, it is bound to destroy the original structure waterproofing, it is recommended to carry out the water storage test after the modification, and then carry out waterproof construction, the pipe side, the dark corner position should have waterproof construction, even if the plumber or plasterer has done it in the early stage, it should be chiseled into the structure and re-treated with waterproof rigid materials, and the wall moisture-proof should be in contact with the mortar stucco layer, and the original white ash surface layer must be cleaned up. Then use a rigid waterproof material to evenly scrape the height, and seal the raw surface of the original stucco layer, the chiseled parts of the wire pipe and the small holes. Any waterproof material has strict requirements for the base, especially the bathroom part, conventionally the part of the waterproof should choose polymer water-based composite waterproof coating construction, not allowed to be oil-based waterproof coating construction, because most of the oil-based waterproof coating solvent is volatile chemicals, a long time is extremely harmful to the human body, if the waterproof membrane is selected as the part of the fortification, even if the waterproof effect is achieved, but the membrane and the floor tile are obviously isolated, which will cause the floor tile to be hollow, not to mention the wall. The ground needs to be dry during the construction of water-based waterproof coatings.

Clean. No sand, shelling, yin corners need to be made into small arcs, the formula should be accurate, the thickness should be uniform, and the moisture-proof requirements of the wall should be the same. Carry out the water storage test to make sure that there is no leakage, and then evenly apply a waterproof coating at all the construction coating film positions and sprinkle dry cement fine mortar before drying, so as to facilitate the adhesion of floor tiles to the coating film.

Why is the ground not slippery, it can be done waterproof.

It is possible that the treatment is the same as that of the wall, which is brushed, so it does not affect the waterproofing.

OK.

There are several ways to see which kind of contractor is used for commercial use There are waterproofs made of polypropylene waterproof cloth glued There are also waterproofs made of tangible waterproof components No matter what waterproof material is made of waterproofing, the thickness will not be too thick One centimeter is very likely to damage the waterproofing If you want to cut it off, you need to do it again to do waterproofing.