-
Put flat water first, and then make a slope at the drain and the farthest point, and the slope is 1cm per meter of length.
-
In order to smooth the flow of water in the bathroom, the slope between the floor tile and the floor drain should be the lowest point of the floor drain, measured with a level, and the ground in the bathroom should be inclined to it at any position. The lowest angle (height difference) is 1 centimeter, and construction is usually kept around centimeters.
The ground is facing the drain, and the drainage slope is 2% and 3% for the first voyage. Toilet backfill, leveling, should be drained as the center to the four directions of radiation, find the slope, scrape with a ruler, plastering surface requirements flat, no pits, no gaps, no sand, no water accumulation.
Not only the ground needs a slope, but also the slope of the water pipe should be paid attention to when the water pipe is installed, the slope of the water supply horizontal pipe to the water discharge device or water distribution point, and the water supply inlet pipe should have a slope of not less than the slope to the outdoor water supply pipe.
-
Make a little slope when plastering mortar.
Wouldn't it be enough to raise the track to balance? Add some ground height.
600 800 yuan if you take it apart.
First of all, try to buy non-slip tiles at the beginning. Non-slip tiles are slightly more expensive than ordinary tiles, but it is worth paying for the convenience of life and the health of your family. >>>More
The slope is too large, and the poop falling directly into the water will make a splash and stain our buttocks, so we can't do too much slope. >>>More
Glazed tiles on the walls, vitrified tiles on the floor.
It is recommended not to follow the designer when buying, and do not disclose your decoration address to the merchant, and then talk about it after the transaction. >>>More