-
Anonymous users2024-01-24The possibility of sending you a copy is not high, after all, this is not public in each factory, and the specific calculation method can tell you as follows:
After the furniture drawings come out, the materials used for each board are calculated (calculated area) and panelized, so that the utilization rate of each board reaches the highest; Basically, this one is from the panel to the drawer. Adding these calculations results in the area to be used is the size of the plate used, and we generally use 80% utilization. Then multiply the unit price of the board.
PackagingFirst of all, you have to know the unit price of packaging materials such as bubble foam, cartons, etc., and then calculate the volume, like a package of packaging, panel + 2 side plates + back plate (bottom plate) This can be packaged as a package, and you also have to calculate their volume through drawings (so accurate), and we estimate the general inner list.
In addition, you can make your own formulas for these calculations via Excel.
The most important thing is the source of customers, the investment in the panel furniture factory is not large, some equipment, just fine, and then invite a few workers, the preliminary calculation of 20W up and down.
15854671990 Liu Jinbao, I've been doing this for 3-4 years.
Jinan production engraving machine manufacturers less than two or three hundred, large manufacturers and big brands to Jinan Gete, Jinan local users, standardized production, large output, can go to Jinan furniture factory to see the actual processing effect. >>>More
Panel furniture production equipment should be about 10,000 precision saws, one edge banding machine, about 9-100,000 yuan, about 40,000 yuan for a three-row drill, and about 3,000 yuan for an air pump, so the machine should be about 200,000 yuan, plus plant rent, materials, etc., it is estimated that 500,000 yuan can be operated in the early stage.
Don't spend much, 2 to 3 machines, about 20,000 yuan (good quality), and then buy materials, save thousands of boards according to the thickness of the board (estimated 5,000), and then make a small number of samples, it is best to rent a store with a better location (the deposit plus decoration is estimated to be 10,005). Put the sample in the store and ask someone to look at it in the store every day. Then prepare a little working capital, 20,000, 500 square meters, if the location is a little better, it is estimated that it will cost about 7,000 a month of rent, this first of all, small customers to start, a single piece is also done, advertising to do a little better, the signboard to make a little bigger, the best to reach passers-by next to the factory know the name and products of your factory