My house is a duplex structure, the living room is empty, I want to lay floor heating, I don t know

Updated on Living room 2024-09-10
1 answers
  1. Anonymous users2024-01-24

    The effect of underfloor heating should be the best, because people's feet are the farthest away from the heart, and the body will basically not feel cold when the feet are warm. In addition, from the thermal consideration, it is also good for floor heating, because floor heating is a large area of uniform heat dissipation, convection is more sufficient, and it feels comfortable, while the radiator is only in local convection, and the whole room heats up slowly, especially your living room space is relatively large and high, and the hot air stays in the high place for a longer time, so you are supported to use floor heating.

Related questions
3 answers2024-09-10

How many floors is in your house? If it is the first floor, it must be poured by itself and there must be columns, otherwise it is not safe.

2 answers2024-09-10

Make a corner of the shoe cabinet decorative partition out, don't do it too long, 70-80 cm is about the same, sure, so that the use of a little bit of trouble, but there must be a trade-off.

1 answers2024-09-10

It is to make the floor slab of the shared space into a bedroom! So that's not a problem just that. Whether there is a problem depends on the overall floor plan of the house and the accuracy of the direction of the door to judge the good and bad of each aspect. Hope it helps.

1 answers2024-09-10

Whether the living room with the empty ceiling of the duplex is calculated on one or two floorsIt is not calculated according to two floors, if it can calculate the construction area, the empty area is calculated. >>>More

3 answers2024-09-10

There are two problems to be solved in structural design, one is the strength problem, the other is the stiffness problem, that is, the structural deformation, the deformation is too large, the flutter you say is too large the deformation, and the need to reinforce is estimated to be the steel beam section is small. If the floor tiles are removed without trembling, it may be good to use the floor that conforms to the floor. Otherwise, the steel beams should be reinforced or replaced with larger ones.