-
Anonymous users2024-01-24There are many reasons why the toilet can't pump water. In fact, it is very simple to investigate, and follow the flow to find it. Troubleshoot step by step.
First, open the main valve [also called the angle valve] to determine whether there is running water, and second, open the lid of the water tank and observe that there is no water on the water tank. Whether the piston can be plugged. If you can't plug it, it will leak, and the water tank is not up to the switch, so you won't get on the water The toilet tank accessories are divided into three parts.
The first is that the drain valve is directly below the button, and the second is the inlet valve, which is the part of the hose connected to the outside of the water tank, which is generally next to the drain valve. The third part is that the buttons are divided into full-row buttons and half-row buttons. Three toilet seats are covered, check whether the button can reach the inlet valve, if so, adjust the inlet valve to the orientation, and then see if the float or float of the inlet valve can move up and down freely, this is very important.
If you get stuck, the water won't get in. Usually there are adjustable crosseyes on the pontoons, and you can twist them in a clockwise direction to see. If the float is suspended in the air when there is no water, it means that it is broken and the water inlet is blocked.
Fourth, fill the water tank to see if the pontoon can float freely. If the problem of water inlet is solved. Then there is the problem of drainage, which is also the problem of flushing.
See if the plug of the plug in the tank, also called the float, is damaged. Whether the float and button connection are loose. If it is loose, you can tighten it 5 to see if the button is elastic.
It is easy to rust when the spring enters the water for a long time. The working principle of the toilet is nothing more than pumping--- storing water --- releasing water. Just a few things, step by step.
That's right, the water is stopped, and the toilet is still on when there is no water, and it is haunted.
This is the toilet inlet pipe, that is, the water inlet filter installed in the toilet is blocked by sediment, you can turn off the toilet water inlet switch, some have a filter at the water inlet pipe, mostly in the toilet, remove the water inlet pipe connected with the toilet, remove the water inlet valve, there is a filter at the bottom of the water inlet valve, there is a strainer at the bottom of the water inlet valve, there is dirt and sediment in it, rinse it in the clean water, and then install it back, tighten the screws, install the water inlet pipe, and then turn on the switch to see that everything will be normal on the water.
It's that the foam buoy is stuck, try it with your hands first, and you will know that it is stuck; The most important thing is that the new accessories are not standard. >>>More
If the toilet is always on the water, maybe it is a problem with the water tank, you can check whether the material or parts of the water tank will be too old, because some small parts are relatively unused, and it will not take long for the phenomenon of damage, if it is used for a long time, there will be problems, then it is a phenomenon of natural wear and tear, as long as it is replaced, the phenomenon of leakage on the toilet does not stop and cannot be eliminated, it may be because of the sewer pipe, because the function of the sewer pipe is used to connect the toilet tank, It is also possible for a major conveyor pipe to have this problem.
The possible cause is that the water stop valve is broken, and you should check this problem.