-
Anonymous users2024-01-24There are large and small cycles of heating installation.
Because your home is a big cycle, which is the so-called tandem. Because the heating enters the bathroom first from the main pipe outside the house, the toilet is the hottest, and then enters the master bedroom, the second bedroom, and the living room in turn. Because the front room absorbs a certain amount of heat, the temperature of the last room decreases to a certain extent.
-
Anonymous users2024-01-23My house is the same as yours because the water comes in from the bathroom first and then out of the living room. There is a deflating raft on the heating, if there is gas in the heating, it is not hot, you use one and catch a little, unscrew a little to release the gas, and the water can be circulated when there is no gas. If you don't know how to get it, you can find a property or pipe heating, and they are obliged to repair it if they pay so much heating bills.
-
Anonymous users2024-01-22If the living room is equipped with high-level wall-mounted heating, you can turn off the water and return valves of the heating with a relatively high temperature, and force the high-level heater to increase the amount of water and water.
-
Anonymous users2024-01-21It's very simple, find the property, it must be where the heating is blocked, the heating is not smooth, find your heating company, and let them solve it.
The installation of radiators at home can be selected after the decoration is completed, and at the same time as the installation of water and electricity lines. The location of the radiator installation varies according to the room with different functions, and when determining the location of the radiator, it is necessary to consider both the problem of convection and the problem of heating cold air. >>>More
1. The valve is not opened.
If you encounter a radiator situation at home, you should first check whether the radiator valve is open. The radiator valve is generally a spherical valve, the valve has generally been adjusted before leaving the factory, generally only two directions, the handle is open when it follows the pipe, and the rotation is 90 degrees to close. >>>More
Remember, do not put water on the radiator, the small valve of the radiator is used to reduce pressure, you can test the radiator by hand, whether there is a significant difference in temperature between the upper and lower parts, if there is a decompression, increase water circulation, it will be fine. If you have a top floor, you can install a circulating pump to improve the poor circulation, if it is not on the top floor, do not use it that will affect others.
1. The installation position of the radiator in the living room. >>>More
You check that the valves of the water separator and water return are fully open. In the past, it could be hot.