What should be done to make the bathroom waterproof

The answer to the waterproof method of the bathroom is: 1. Brush the waterproof paint twice; 2. laying a protective layer; 3. Closed water test; 4. Grassroots cleaning, secondary water storage test. The precautions for bathroom waterproofing are to ensure that the construction site is clean and dry before construction, and the waterproof coating should be full, no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off. >>>More

First, the waterproofing was not done well at that time, and many owners asked the plasterer to do it when decorating, which led to a lot of negligence and inadequate details when decorating. Second, after the waterproofing is done, when the bricks are laid, the bathroom door stone is not blocked with a leak plugging treasure, and the water will seep to the outside. Third, after a long time, there are cracks in the floor slab, and the water seeps down. >>>More

First of all, the ground has to be leveled, 30 cm from the ground wall tiles are also removed after leveling, to dry, two kinds of waterproofing: membrane, coating, if you use membrane, it is best to use EPDM waterproof membrane, if you use paint, it is best to use rubber modified asphalt waterproof coating, the ground and wall are done together, after doing it is like a basin, it is best to paint three times with paint, the main part is the floor drain pipe mouth, toilet pipe mouth, the ground and the wall joint, the weak part of the ground, do it carefully clean the pipe mouth with a toothbrush, Rinse while brushing, clean with waterproof cement carefully wipe the ground and the joint of the pipe mouth, the water does not leak inside the best to add some asbestos powder, after thoroughly drying and the ground together with the overall waterproof, the toilet fixed wire should be laid first, more than one centimeter from the ground The mouth of the screw is wrapped with masking paper and do not stain the waterproof coating, the following part is also brushed with the ground with waterproof paint to prevent the water from seeping down the fixed wire in the future, and you can put the water after drying, soak for 48 hours, the water should be 10 cm deep, otherwise it will be tried in vain, You said that the plumbing pipeline in the seal before taking a few photos, in case there is a problem in the future can check the location, with the high grade cement all sealed and leveled, the key is that the cement must not be bought fake, otherwise it is also done in vain, good cement looks blue after drying, high density, high hardness, high strength, not easy to leak, do not use white cement to make up the seams after sticking the floor tiles, you go to buy a few bottles of Taimao brand plastic steel clay, but also to prevent not to buy fakes, floor tile joints, wall corner joints, etc. are all made up with plastic steel soil, if you do this, There is absolutely no possibility of a water leak in 10 years, unless the house settles and causes a slight crack in the ground, and then raise the problem. I wish you success! >>>More

Oh, but also think that hardcover houses can rest assured, it seems that construction quality problems in the so-called real estate elite is inevitable.

Both the walls and the floor should be done.

The wall, the shower wall is not less than the meter, and the rest is not less than the meter. >>>More