The kitchen sink and shower faucet have watermarks, how to remove them

Updated on Kitchen 2024-09-26
6 answers
  1. Anonymous users2024-01-24

    Do not use steel wool balls and wire brushes to clean the surface of stainless steel, so there will be scratches, if there are dirt marks, with a little grinding powder (can be replaced by edible flour) repeatedly wiped, it can be as bright as new.

    After each use, you can use a rag to scrub for a few minutes and then wipe the stainless steel surface with a dry cloth, otherwise the countertop will leave a watermark after drying.

    Maintenance of the sink.

    1. After the sink arrives, if the house is still being decorated, it is necessary to pay attention to the ventilation of the windows to avoid oxidation of the surface of the sink by the corrosive gas emitted by the decoration materials, which will cause the sink to rust.

    2. For newly renovated customers, you can apply a layer of oil on the surface of the sink, which will not be easy to rust than ordinary sinks when used; The same can be done when you don't use the sink for a long time! And if there is rust, wipe it with a toothpaste at home, which can have a good rust removal effect.

    3. After using the sink, try to rinse and dry with clean water, do not let the water droplets remain on the surface of the sink, the water with high iron content may cause the formation of brown-red traces on the surface.

    4. If the water that has not been wiped dry has produced water stains that are difficult to remove, you can use a low-concentration vinegar solution to remove this deposit, and finally wash it completely with clean water.

    5. Clean the sink frequently, preferably with sponge, cloth and neutral detergent.

  2. Anonymous users2024-01-23

    You go to the paint shop to buy No. 1500 sandpaper, about 2 yuan, first let the sink store water to the place where the watermark is submerged, and then wipe it off with sandpaper It's a bit laborious, and the faucet can be soaked with water and then wiped.

  3. Anonymous users2024-01-22

    Dish soap.

    After wiping it clean this time, you must change the faucet to a good one, the watermark under the faucet is caused by the faucet being broken and slowly dripping for a long time.

  4. Anonymous users2024-01-21

    With vinegar limescale calcium carbonate accounts for a large proportion of easy cleaning with vinegar.

  5. Anonymous users2024-01-20

    I'll tell you, one of the best ways to use metal decontamination powder, which can remove stains, can prevent rust, and is extremely bright.

  6. Anonymous users2024-01-19

    Try it with a cloth dipped in toothpaste or stain remover.

Related questions
2 answers2024-09-26

If you really believe in Feng Shui, then du

You need to know a little bit about Kanyuzhi >>>More

3 answers2024-09-26

To remove the watermark from the stainless steel sink in the kitchen, you need to have warm water, a toothbrush, dish soap, and a rag. >>>More

1 answers2024-09-26

Is the water valve turned off over there? Or is the water pipe not connected? How do you know what's going on without checking.

3 answers2024-09-26

Or there is a switch in the middle of the pipe, there will be no water Hello. If it is connected normally, see if there is a separate switch.

3 answers2024-09-26

The solution to the blockage of the kitchen laundry sink and the vegetable sink: >>>More