How to test the water in the bathroom takes a few days

Of course, you have to do a closed water test, and plug the surrounding area of the bathroom with water 10 cm high and observe it for a day or two.

Plug the floor drain, plug the door, put water in the bathroom, and the water level is higher than the corner of the garden, generally 5-6cm

The water test time is 24 hours, and it is recommended to try twice, once after the waterproof layer is completed, and once after the tile is paved.

Hello, I'm glad to answer your confusion, in all areas of the home, the most contact with water is the bathroom, so waterproof to do a good job, so what are the specific steps of waterproof water test? Let's follow PChouse to find out.

1. Remove the original floor tiles and wall tiles.

Remove the original wall tiles and floor tiles, this step is generally for the second decoration of the old house, if it is a new house, then this step can be skipped, generally using a gray knife, the scraper can also remove the original floor tiles.

2. Plug the sewer pipe.

The waterproofing of the bathroom is usually carried out after the completion of water and electricity, so the sewer pipe must be blocked before doing waterproofing, the purpose of this is to avoid blockage, the small water pipe is blocked with a nut, and the large sewer pipe (such as the toilet sewer pipe) is blocked with PVC winding film.

3. Ground and wall leveling.

The leveling here is usually the ground plastering treatment, the ratio of mortar cement and sand is between 1:2-1:3, pay attention to the thickness of the leveling should not exceed 3cm. The horizontal and vertical errors should also be controlled within 5mm.

4. Make a waterproof layer.

First of all, the wall will be slotted with cement to clean up the base layer, the details of the additional layer construction, in the pipe root, floor drain, yin and yang corners, and other weak parts that are easy to leak evenly painted, painted waterproof paint twice, painted longitudinally and horizontally, but also remember to do a good job of protective layer, after waterproof drying, release water to do 48 hours of closed water test.

Ask the bathroom, waterproof and then toilet that has a nest to test waterproof.

First of all, the wall will be slotted with cement to clean up the base layer, the details of the additional layer construction, in the pipe root, floor drain, yin and yang corners, and other weak parts that are easy to leak evenly painted, painted waterproof paint twice, painted longitudinally and horizontally, but also remember to do a good job of protective layer, after waterproof drying, release water to do 48 hours of closed water test.

It takes at least 24 hours to see it.