-
Anonymous users2024-01-24Be sure to understand the role of each of the above components in the work.
When discharging water, pull the drain knob, and the knob pulls up the water outlet plug through the lever. In this way, the water from the tank will be released. After the water is released, the outlet plug falls down, blocking the water outlet.
At this time, the float is also at the bottom of the tank due to the drop of the water surface. The fall of the float drives the lever to pull up the water inlet plug and let the water enter the tank. As the water rises, the float will gradually increase due to buoyancy until the inlet plug is pressed down by a lever and the inlet is blocked.
This fills the tank with water again. Think about it, what is the purpose of the adjustable knob?
When the inlet pipe leaks due to a malfunction (e.g., the inlet plug fails to block the inlet or the inlet pipe breaks), the water level in the tank will continue to rise and eventually overflow the tank. And the setting of the seepage pipe solves this problem.
When the water level rises to the seepage nozzle, the water flows into the toilet bowl from the seepage pipe and does not allow the water to overflow the tank. When the inlet pipe is working normally, the water surface in the tank will not reach the seepage nozzle, so there is no need to worry about the water flowing away.
The smart toilet of FRAE intelligent bathroom is designed without water tank, there is no problem of storing aquatic bacteria, and it uses an imported instant heater to control the water temperature immediately.
The steps of the water level adjustment method in the toilet tank are as follows: >>>More
This water belongs to the general type, from the description to know the situation, look for a small plastic plaque in the water tank to see if there is a small plastic plaque, that is a positioning pin, if there is no can make one, the maintenance method is, move the jacket of the water valve down to the appropriate position, rotate the jacket to (left or right) a little, stretch it up by hand when it does not move, insert the small positioning pin from the bottom of the jacket along the groove of the inner rod in the middle of the two tubes, this is the general maintenance procedure, see if it is feasible, I wish you a smooth and successful operation. The dowel pin is the lock referred to in the figure.
A flush toilet consists of the following main parts: inlet pipe, outlet pipe, seepage pipe, plug (inlet and outlet), float, drain knob and lever. Be sure to understand the role of each of the above components in the work. >>>More
The inside of the water tank is also a place where there is more scale, after using porcelain descaler to remove the scale according to the instructions, choose a small commodity called blue bubble in the supermarket and put it in the water tank, it has the effect of sterilization, cleaning and deodorization, which is very convenient, you might as well give it a try.