What steps are required for the installation of European style crystal lamps, and how to install cry

How to install a crystal lamp in the living room

First of all, we will open the packaging of the crystal lamp and find the following picture.

You'll find a cross iron frame, which I call a "back strip", and there will be four screw caps on the back strip, align the four empty ones on the lamp, and then tighten it.

After tightening, fix the back strip to the roof of the shed.

After fixing, remove the white film on the lamp.

After tearing off, connect the two wires of the lamp with the two power cables on the roof of the shed and wrap them with adhesive tape. Insert the four eyes on the top of the lamp into the screws on the back strip, and then strap them with screw caps, so that the lamp can be fixed.

Then take out the parts inside the lamp.

Tear off the film of the iron sheet in the picture below.

After tearing, follow the instructions of the drawings to string the beads one by one.

Put it aside first, take out the bulb, screw all the lights on, turn them on to test the lights, and then try the remote control to ensure the normal use of the lights.

Then hang the strung iron piece on the lamp, hang the long circle in the middle, and the side will become shorter and shorter, and the drawing will teach you to hang a few strings of hanging beads.

Once hung up, you will see that there are three long and short aluminum rods, and use a ring to thread them all.

There are holes at both ends of the aluminum rod, you wear them with rings, and then there is a crystal ball hanging on one end, and then hang it on the lamp, and after hanging it, the picture below will appear.

Then use beads, thread them through the glass like a DNA model, and hang them up (the drawings will indicate where to hang and how many strings to hang).

After all of them are hung up, the effect of opening will be very good.