What photographic equipment is needed for furniture photography solutions

Updated on furniture 2024-09-17
3 answers
  1. Anonymous users2024-01-24

    Pay attention to whether there are any corners that are particularly lacking in lighting but need to be photographed, and if so, focus on filling the light in that direction. The fill light does not have to be a flash, if the angle can match, the amount of fill light is not high, try with a larger reflector.

    In addition, it is estimated that you should have a wide-angle lens, and if you can, do not use a zoom one, because there may be a barrel-shaped deformation, which will make the lines of the wall bend and be ugly.

    Ideally, a tilt-shift mirror can be used to correct the perspective and capture the effect of vertical grids at any angle.

  2. Anonymous users2024-01-23

    This depends on what you are using to take pictures, if it is ordinary, the general camera or the entry SLR can be, if the lighting is good, the general flat light is good, the flat light is better to swing, and the shot is clear!

  3. Anonymous users2024-01-22

    It depends on what kind of effect you need, and the configuration above should be very good. If you have a better technique, you can also use a small power, but you may not be able to shoot the desired effect at one time.

Related questions
1 answers2024-09-17

Advantages and disadvantages of water-based paint.

Water-based paint is a new type of environmentally friendly paint that uses water as a diluent and does not contain organic solvents, which does not contain formaldehyde and other harmful substances to the human body. It has a wide range of applicability. Water-based paint looks like solvent-based paint with the same color, fullness, good flexibility, and better waterproof performance. >>>More

1 answers2024-09-17

oh You can refer to Guangdong Hongye Furniture they stand, there is a project that is a supporting case of office furniture engineering, and the suggestions in it are still more detailed and nutritious.

3 answers2024-09-17

Hello, friend.

First of all, the design of this house is very unreasonable, and it is very bad to analyze the door entrance to the bathroom from the perspective of feng shui. >>>More

5 answers2024-09-17

In fact, this link is not with hot melt adhesive, but with spraying glue! This will be very thin Very sticky, there will be no sound products There is also a point Now advocating environmental protection, many mattress factories do not use glue I hope you improve.

11 answers2024-09-17

Thoroughly clean the dead corners, pay attention to sewage discharge, dump garbage in a timely manner, pay attention to air convection, and set up mosquito killer lamps in places where mosquitoes and flies are easy to enter, etc., I believe that these points can greatly reduce the number of mosquitoes and flies.