The phone fell into the toilet, and after cleaning it with tap water, it was taken to the repair sho

Updated on Toilets 2024-09-10
1 answers
  1. Anonymous users2024-01-24

    Electronic water can not be dried with a hair dryer, to air dry, hair dryer will blow the motherboard blister.

Related questions
The phone has been dismantled, and it fell into the toilet today, and there is a little bit of water
2 answers2024-09-10

Hello, please shut down immediately. Don't use a hair dryer. >>>More

The phone fell into the toilet and blew it, and it was also cleaned, and no parts were broken, but t
5 answers2024-09-10

If the phone is dropped in the toilet, it should be cleaned within 1 hour, and the phone will be damaged after this time, and even if it is repaired, it cannot be guaranteed to be used stably for a long time. Replacing the touch screen is not very expensive, so try another one.

If the contact lenses fall out of the toilet, can they still be used after cleaning with the care so
7 answers2024-09-10

It's best not to use it. Contact lenses are in close contact with the eyes, and if there is any dirt left on them, even a little bit will cause great damage to the eyes day after day, so it is recommended not to use them.

My phone fell off the toilet a few days ago, and I took it to the mobile phone store to repair it, b
1 answers2024-09-10

The parts in the mobile phone are very sensitive, and they burn out if they are slightly short-circuited, and they can be turned on at that time to indicate that the water has not penetrated into it, but the screen is turned on, after the power is on, it will lead to a direct short circuit, and the black screen can be turned on after the water is dry, or directly sent to the after-sales service, to see if the electronic components inside are burned out.

The phone fell into the toilet, took it to repair, the motherboard corroded, and it didn't take long
4 answers2024-09-10

It is generally difficult to repair the water ingress of the mobile phone, this is because the lines of the mobile phone circuit board are very dense and thin, and it is very easy to be corroded, and the motherboard can only be replaced, but the price of replacing the motherboard is high, and the new mobile phone is not much cheaper.