-
Anonymous users2024-01-24When the bathroom does a waterproof water test, the best way to plug the floor drain is to use a rubber paper bag to tie the mouth of the bag with half a bag of sand, put it on the floor drain, and then compact the periphery, and fill the water with water, because the pressure of the water is deeper, the greater the pressure, and it will not leak.
Hope it helps you, thank you for adopting!
Just find some fine sand or dirt to use outside – just clean up after the closed water test!
After the bathroom is waterproofed, it needs to be thoroughly dried, so that it can do the closed water test, you can contact the residents downstairs in advance, so that the leakage can be informed in time to avoid unnecessary losses of the downstairs residents When doing the closed water test, the depth of water storage can not be less than 20 cm, and the time can not be less than 72 hours, and the water level does not fall is qualified.
After 24 hours of waterproofing, the water will be closed, and the water level at the highest point of the plane shall not be less than 2 cm. The entrance is built with a waterproof edge. Acceptance after 24-48 hours of water closure.
The reason for the leakage of the toilet waterproof and closed water test is caused by non-standard construction. If the waterproof is done, if there is no standard closed water test inspection, it will eventually lead to water leakage. >>>More
Fill the plastic bag with water on it Choose the floor drain to choose the Jindel floor drain This kind of floor drain panel has a water area of more than 2800 square millimeters, plus a unique siphon function, to ensure that the drainage volume can reach up to 80L min in a normal state, which is much greater than the municipal tap water pressure, and the 6-minute burst pipe flow bath or something no longer has to worry about drowning feet.