The toilet drains slowly

Updated on Toilet 2024-09-26
5 answers
  1. Anonymous users2024-01-24

    Professionals.

    Reason 1: The outlet of your toilet and pipe is too small (sloppy during installation).If there is a little debris, it will not go smoothly into the water.

    Reason 2: Hard objects have fallen from the toilet. Plastics and stuff like that. The effect is not obvious after dredging.

    It is advisable to find a professional to remove the toilet bowl and reinstall it. Or a new toilet can do the trick.

  2. Anonymous users2024-01-23

    == Don't use the toilet to suck the more you use it, the worse it is that the lower part of the toilet is easy to block Either find a toilet to pass it or go to the store downstairs to buy a slightly harder rubber pipe One meter is enough Probably similar to the rubber pipe of the water heater Pull a little bit to flush it in the future.

  3. Anonymous users2024-01-22

    The flow of water is small, the pressure is small, it can't be flushed clean, and the second flush is a waste of water, if in order to save water, the home can be used to wash clothes and vegetables and other domestic water, so as to achieve the purpose of saving water.

  4. Anonymous users2024-01-21

    It must be a large blockage, poke it in with a rubber hose to see if it can be unblocked.

  5. Anonymous users2024-01-20

    It should be that there is a blockage in the sewer, and it is best to ask a professional to dredge it.

Related questions
2 answers2024-09-26

It is very likely that the return air hole of the toilet is blocked, and the gas inside cannot be released, so the drain will be very slow, if the gap under the base is not sealed, it actually plays a role in deflating, so the drain will be unobstructed, as long as the return air hole is dredged.

6 answers2024-09-26

It's not the toilet that is the fault, it's the septic tank that's full, and the land where I rented a house also appeared, and the landlord was asked to get it done. It may be blocked, the detection method is to take a basin of water and flush it directly, so that it is not blocked, otherwise it is blocked. 2. If it's not blocked, it's the toilet itself. >>>More

11 answers2024-09-26

The toilet is not clogged but the drain is slow: the fittings are damaged, the water level of the inlet valve is low, and the toilet quality is problematic. >>>More

4 answers2024-09-26

You go downstairs or upstairs to the neighbor's house to see if it is similar to your house, and then look for a solution, it may not be your house that is blocked.

11 answers2024-09-26

Because it is a water-saving toilet, press more and more, press less and use less, and use it in large and urinated.