1 83 9 How to partition the bathroom with dry and wet

Bathroom dry and wet partition, this is now only AIA has, I am the bathroom integrated ceiling AIA, see they have this dry and wet partition on the installation. The dry area is warmed by air, and the wet area is heated by light waves.

The bathroom is definitely the top priority of a decoration, and I personally must be a little more demanding on the decoration of the bathroom than other aspects, because I think that whether a home is clean, tidy and comfortable, the bathroom is a very important measure. >>>More

OK. Use lights and winds to keep warm.

There is also a kind of bath bomb on the market that integrates lamp heating and air heating, which is a collection of two sets of heating systems, which is more comfortable and has a better heating effect than simply using lamp heating, and is faster and more energy-saving than simply using air heating. However, it is conceivable that the disadvantages of lamp warmer and air heater also have at the same time. >>>More

Installed on the side of the dry and wet partition of the dividing dry area, there must be backwater in the wet area, so the ground will not be very flat, there will be a slope, if it is a sliding door, sliding door, hanging door and simple shower partition, the brick is directly installed on the brick line, if it is a swing door, installed in the brick and outside the brick, but to cooperate with the bricklayer master to do it, if it is a folding door, it is also recommended to install it directly on the brick.

It is still necessary to have space to distinguish so that the water vapor in the shower does not fill the entire bathroom, and the dampness that affects too many parts will speed up the damage everywhere, so it is best to distinguish them.