-
Anonymous users2024-01-24This hole margin is not determined by a single board. Usually involved.
When it comes to the size of another board or hardware, of course, if you draw the first part of the furniture structure first, this size is usually determined by yourself.
Consider that the spacing between the holes and the holes is a multiple of 32, and usually the margins on both sides are divided in the middle, so that the left and right sides can be interchanged.
-
Anonymous users2024-01-23It's not a matter of calculation, there are a lot of things to consider, you can buy some furniture design books to see!
It is very convenient to use UG to calculate, and the speed is also fast, and the hardware can be built into the model and positioned directly!
The hole margin is not determined by a board, usually involves the size of another board or hardware to determine, of course, if the first part of the furniture structure is drawn first, this size is usually determined by yourself. >>>More
Don't divide the two ends evenly when you are working. This seems to be a lot more symmetrical and beautiful, but the consequence is that the front and back of the side panels are not easy to distinguish. If there are many side plates, it is easy to cause confusion, waste time and slow down the speed of hole rowing. >>>More
The hole position of custom furniture can be roughly divided into connection hole and positioning hole, which is determined by the connection process of the furniture factory and the installation process of hardware. For example, the most common three-in-one hole, as shown in the figure below, has different hole diameters, depths, and distances to the edges of different manufacturers. >>>More
According to the row drill bit clearance, according to the 32mm series of holes! Generally taken!