-
Anonymous users2024-01-24Waterproof construction process:
Base treatment: Paste the elevation contour line with masking paper, apply the first emulsion, apply the second emulsion after drying, dry, and close water test.
Construction technology: 1. The base should be cleaned up, and the surface of the original wall and ground should be solid, and there should be no sand, ash or hollowing.
2. Clean the root of the upper and lower water pipes and plug the leakage.
3. Use 10-15?The wide masking paper is pasted with the outline line according to the design and construction height of the wall.
4. The first emulsion brushing construction, the order from top to bottom, from the inside to the outside, shall not be missed.
5. After drying for 24 hours, apply the second emulsion to form a complete waterproof layer.
6. After drying for 24 hours, do a 24-hour closed water test, and the water discharge height is not less than 30?No leakage within 24 hours is qualified.
7. After the surface cement mortar is brushed, it can be directly tiled for construction.
I look for a waterproof quilt directly, and after sitting down, I come to the big 24-hour closed water experiment.
Grassroots treatment and cleanup.
Do the screed. Binding layer. >>>More
If you have a waterproof coating, you don't need to use water without leakage. Water leakage is used only when water is constantly seeping out and cannot be used for waterproof coating construction.
Base treatment - waterproofing - waterproof protective layer - insulation layer - light aggregate concrete - screed layer - paint waterproof - protective layer - tile paving.
Now the bathroom waterproofing uses waterproof paint and mortar waterproofing agent is more common, mortar waterproofing agent because of good adhesion with the wall, high strength, simple construction, waterproof years can be the same life as the building and other reasons become the most commonly used waterproof materials for kitchen and bathroom waterproofing. The specific construction method is as follows: >>>More