-
Anonymous users2024-01-24The water heater is prone to leakage, if your air switch is leaking, it is likely to trip, you remove the leakage switch, try it with the air switch alone, if it also jumps, the water heater is short-circuited inside, and if it does not jump, it is the water heater that is stained with water and leakage, and the ground wire is installed.
-
Anonymous users2024-01-23The water heater has a short circuit.
-
Anonymous users2024-01-22Turn on the switch again and touch the inside of the water heater with your hands.
-
Anonymous users2024-01-21It's hot fast, the circuit breaker self-protection function in the bedroom comes, and your heat is too fast.
-
Anonymous users2024-01-20Hello: Discontinue use. Find a maintenance worker to repair, the water heater has a short circuit, and it can only be used after repair.
-
Anonymous users2024-01-19It's a short circuit, find someone to fix it.
Buy some square sheath wires and buy a 16A three-empty socket to connect it, the original socket has a ground wire and then add a wire, the socket has no place to hide, you can buy a box to fix on the wall.
1. If there is leakage of solar energy, 2 The power of the heater exceeds the setting value of the air switch. 3. The plug change and the ground are reversed.
The neutral and ground wires of the socket are reversed. Because the neutral wire and the ground wire are ultimately grounded, the device that detects whether the socket wire sequence is correct can not detect this error, and the reaction is to light two green lights and the red light is not on, but because the ground wire does not pass through the leakage circuit breaker, the current flowing through the leakage circuit breaker when the load is connected is unbalanced, which causes tripping.
This is there but the detection is missing, it is caused by the line being disconnected or falling off, this can measure the resistance of the ground wire. Some are fake, only a small section of the grounding wire is inserted, and some are which part of the grounding wire has fallen off.
There is no need to unplug the plug of the bathroom water heater frequently, there is a temperature control box inside the storage type electric water heater, after heating the water, do not pull the plug and keep it in the turned on state, it will always remain at a constant temperature. At this point, it doesn't consume a lot of electrical energy. Once the power is turned off, the hot water inside will gradually cool down and will be reheated when the power is turned on again, which will consume more electricity. >>>More