-
Anonymous users2024-01-24It's a little hard to get it. Gluing that is nonsense, something is definitely going to happen. It's better to smash a brick and re-get it down, the cost is not very large, and it is more assured. In addition, it means that the pipe you use is not very good.
-
Anonymous users2024-01-23I have a suggestion, if the pipe in the wall is not damaged, you can clean the mouth in the wall, use the hot melt connection method to lead the mouth out, and make it surface-mounted.
-
Anonymous users2024-01-22It's very simple: first chisel the inside of the taper little by little, or buy a 4-point tap, and break the short end in the tap.
-
Anonymous users2024-01-21Hello buddy???
Of course, you have to smash the bricks, the elbow must be repaired well, and I am the decoration company that will leak after the leakage, responsible for the renovation of water and electricity, this kind of trivial matter is not difficult for me to ask, what brand of pipe do you use, if it is Xingde, then you can send it, and you can pay a hundred for a bad one, which is better than Jinde, and cheaper.
-
Anonymous users2024-01-20Nabs! smashed and reloaded, don't deal with it, my family's are all smashed, and you have to reinstall it to deal with it.
-
Anonymous users2024-01-19It's best to follow the advice of the plumber master!
-
Anonymous users2024-01-18A more reliable way is to smash the reload.
-
Anonymous users2024-01-17Is it a garden inside? The amount of one is 25It's still 20, use a hot melter to pick out a section, it should be hot inside, it is estimated to be 20, cut a section of 20 tubes and burn it.
The difference between the temperature inside the pipe and the indoor temperature causes the indoor water vapor to condense and form water plants on the pipe wall. >>>More
If you want to overhaul the elbow, you can change the elbow, so that the solution is more thorough, if you want to repair it, you can buy the plugging king on the line, but there is a possibility of leakage after a long time.
This is the 20 elbow of PPR, you need to cut off the PPR pipe, re-hot melt, there is no other way, because you take any glue, the tape is useless, maybe sealed, but it will not take long and it will leak, the gain outweighs the loss, so you have to smash the wall along the direction of the water pipe, expose the water pipe, and then cut off the PPR pipe, and take the fuser again. In fact, an elbow is about 2 yuan, but if you find someone to install, it will cost more than 2 yuan, because you also have to open the wall cracks, so I suggest that you have better smash the wall along the direction of the water pipe, and call a hydropower to pick it up, so that you can spend less money. I'm from Huai'an, and if you're here, I can help you out.
Bathroom pipe leakage needs to be checked to see if you can repair it yourself, if not, you need to find a professional plumbing maintenance master to repair.
Cut off the damaged part and reconnect it with the same size sewer pipe and the corresponding joint.