I want to have a suspended ceiling, the restaurant wants to make a circle, how to build a wooden dra

First of all, it is necessary to lay a good horizontal line, and determine the pay-off position of the ceiling according to the horizontal line.

Use a percussion drill to drill holes, cut into the mallet, and then nail the strips around the wall – this is the keel along the edges;

Depending on the length of the room, the position of the transverse keel is evenly distributed, generally with a spacing of 80 100 cm (a little more, of course, is better); Measure the size of both sides, and nail the rungs to the keel along the edge with nails according to this size.

If the top of the runghead keel needs to be suspended, you can drill holes and fix the wooden strips on the roof surface, and the direction should be crossed with the rungs keel, and then nail the wooden strips up and down on this wooden strip to connect with the rungs keel below. Starting from 30 cm from the wall, the spacing of the middle part can be evenly distributed, and the spacing is about 80 cm; Before doing this step, it is necessary to pull a construction line at both ends to determine the horizontal height of the rungs keels and ensure that all the rungs keels are on a horizontal plane.

If electrical equipment such as lamps and lanterns need to be installed on the roof, the number of rungs keel can be increased according to the situation to play a role in reinforcement. After this is done, you can install the corner strips of the PVC gusset. This is best fixed with screws.

I won't give you a hundred dollars, I won't give you a dime, I'm just bad, I'm just hateful