-
Anonymous users2024-01-24Be sure to level.
1. Laying solid wood flooring has certain requirements for the ground, and the ground is not strictly required to remain level, as long as it is within a distance of two meters, the height difference is not higher than 3 mm. A simple test method is to stand up the board and see that there is no obvious gap between it and the ground, and pay special attention to the corners of the wall, which are often the most uneven.
2. There are many ways to level the ground, the most flat with self-leveling cement, and the use of multi-layer boards or paving treasures can not only level but also improve the foot feeling (the original ground can not be too uneven), but the cost of these three methods is relatively high, and it is estimated that one square meter will cost 20 yuan. The general method is to use cement mortar to level, the disadvantage is that there are cement to dry for more than two weeks, and there is a considerable time to not be able to get on people, delaying the construction period. There is also a method of using gypsum to mix 108 glue, this method is said to be only used in local leveling, but my whole living room is 40 square meters, and it is done in this way, and there is no problem.
Note that 108 glue should be mixed a little more, and the gypsum should be thinner, otherwise the gypsum will dry quickly, and the large area will not be smoothed.
3. If there is heating in winter, the floor should be transported to the site a few days in advance, so that the board can adapt to the temperature and humidity in the house first, and it is best to do this at other times, but there is basically no problem if it is not dry. Be sure to clean the house before laying the floor, otherwise dust will run out from the kicking feet in the future.
-
Anonymous users2024-01-23The installation of the floor generally requires ground leveling, and the leveled ground is convenient and conducive to installation.
If it is installed by the keel method, it can be leveled with the help of keel without additional leveling;
If the bottom plate method is used, it needs to be leveled, and the flatness before installation should be no more than 5 mm within 1 meter;
If the adhesive method is used, it also needs to be leveled, and the flatness before installation should not be more than 2 mm within 1 meter.
-
Anonymous users2024-01-22If it is installed with the keel method, there is no need for additional leveling, and the keel itself can be leveled.
If the bottom plate method is used, it needs to be leveled, and the flatness before installation should be no more than 5 mm within 1 meter;
If the adhesive method is used, it also needs to be leveled, and the flatness before installation should not be more than 2 mm within 1 meter.
-
Anonymous users2024-01-21Solid wood flooring does not need to be leveled, because the keel can be adjusted in height, and solid wood flooring is three points of quality and seven points of installation.
Any floor needs to be leveled before installation, and it can be slightly uneven, and the unevenness must be dealt with.
It will affect the service life of the solid wood floor.
Consumers will think that the uneven ground should be found to sell wood flooring to help level, in order to sell many wood flooring merchants can only compromise, in fact, solid wood floor sellers work. >>>More
Generally speaking. Home improvement leveling. Self-leveling ground leveling is 3-5 mm. Cement mortar leveling is 2-3 cm. Engineering ground leveling. Self-leveling ground leveling is generally 5-10 mm. Cement mortar leveling is 2-4 cm.
It must be leveled, otherwise there will be a sound after it is paved.
No, there will be a lot of problems later.