-
Anonymous users2024-01-24According to what you said, there is some truth in the workers' analysis.
Now that the ground has been opened, you can take a good look at the water source, and the water will be used normally during this period.
If it is indeed caused by the water accumulation as the worker said, now with the water clearing, the water will be less and less, until there is no water at all, the source of water leakage has been broken, and the backfill layer can be restored, the waterproof layer can be repaired, and the floor tiles can be restored, and the problem will be solved.
If the water source is still uninterrupted, or if it does not dry completely, it is necessary to pay attention to the investigation. Since the upper water pipe has been tested without problems, the suspicion may be that all the sewer pipes, especially the sealing treatment of the floor drain, are likely to be caused by the water flowing into the backfill layer from the gap between the floor drain and the backfill layer, resulting in water accumulation and leakage. In addition, it is necessary to pay attention to the situation next door, upstairs or even outdoors, and the possibility of external water sources is also present.
-
Anonymous users2024-01-23Broken drain pipes or leaking joints. Cause water accumulation in the sedimentation tank!
The sedimentation tank is cleaned and dried, and the waterproofing should be done (the shady angle between the ground and the wall should be made in an arc) The ground waterproofing should be 30 to 40 cm higher than the horizontal line, and the water should be tested for 48 hours after drying. Downstairs observation there is no leakage problem can be done backfill leveling, backfill is done dry and then do the second waterproofing, (the yin corner does not need to do the arc, the top should be a towel brick,) the wall should also be waterproof, at least meters high, do a good job of tiling! (When hugging the sewage and drainage pipe, the interface must be connected tightly, and I am afraid that it will be loose when backfilling.) ）
-
Anonymous users2024-01-22It may be that the bathroom waterproofing of your home was not done well during the renovation period, and there is a leak in the pipeline or a leak in the pipe connection when making plumbing.
-
Anonymous users2024-01-21The main thing is that the water supply and drainage pipes in your bathroom are not broken.
Then still put all of the above.
Is the downstairs an integrated ceiling or gusset?
Be sure to open it to see if it is a pipe leak or a waterproof leakage, you can see that there will be water droplets hanging under the pipe leaking pipe, and it will appear again after wiping it dry, and the waterproof leakage can see the cement of his roof damp. >>>More
There are four sources of water leakage: leaking water pipes, leaking pipe drains, water from the floor, leaking water from roofs or exterior walls, and if suppressed, the first can be eliminated. The rest of you think about it yourself and then exclude. Let's take some pictures and I'll help you analyze them.
There are several possibilities, one is the pipe leakage, the second is that the waterproof is not done, and the brick mortar is not satisfied with the quality of the later grout agent or is not tight, the third is that the shower mixer is not tightened when installing the asymmetrical wire, and the water flows down the inside of the brick and seeps through, which is also related to the waterproofing is not done! >>>More
Now you can't find the cause of the water leak?
The water pipe leak is leaking 24 hours a day. >>>More
Summary. You can close the toilet water inlet valve first, and the reduction of water leakage means that there is a leak at the water pipe; To eliminate the leakage of the upper water pipe, you can open the faucet and flush the toilet, floor drain, etc., and there is obvious leakage, you can judge that the sewer pipe is leaking. >>>More