What should I do to make paint in the bathroom?

Bathroom brush waterproof paint process.

1.Before construction, ensure that the construction site is clean and dry, and the waterproof coating should be coated with no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off. The coating height is consistent, and the thickness should meet the requirements of the product.

Then start brushing the first waterproof paint requires more than millimeters, which cannot be decided by the number of passes. The pipe root and the corner of the wall are reinforced, and after the surface is dried at room temperature for 4h, then a large area is brushed and scraped, and there shall be no leakage and bubbling.

2.Brush the waterproof paint a second time. Note the first.

First, the second waterproof coating needs to have a certain time interval, and the second time can only be carried out after the first coating is dry, and the specific time depends on the coating. If the interval is too short, the waterproof effect will be greatly reduced. The façade is painted first, then the plane, and the direction of the next painting is perpendicular to the previous one.

When the final coating film is semi-cured, the coarse sand particles are thrown to facilitate the combination with the cement mortar in the future. The waterproof layer on the ground should be painted 300 wide outside the bathroom door. The waterproof floor waterproof layer should be 200 above the ground, and the wall waterproof layer of the bathroom with shower should be 1800 above the ground.

3.Lay a protective layer. In order to prevent the subsequent construction from damaging the waterproof layer, it is necessary to lay a protective layer on the surface of the waterproof coating. The protective layer should be completely covered with the waterproof layer, no omission, firmly combined with the base layer, no cracks, no bubbles, and no falling off.

4.Closed water test. During the closed water test, the water at the highest point of the ground should not be less than 2 cm, and it should be stored for at least 24 hours, and it will be qualified only after observing that there is no leakage. If there is a leak, it needs to be redone, and it must not be negligent.

1. The base layer is clean and dry;

2. Apply the first waterproof coating (water-soluble or solvent-based);

3. Lay the first layer of non-woven fabric to strengthen the carcass while it is wet, pay attention to flattening, and drive out all the bubbles.

4. After drying and hardening one cloth, apply the second coat + strengthen the carcass for the second time;

5. The second cloth and the second coating are dried and hardened and then applied to the third coating;

6. After drying and hardening, it is handed over to press water;

7. If you do two cloths and four coats, the last surface layer should be painted twice;

8. After the pressurized water is qualified, the protective layer will be made and the pressurized water will be handed over;

Attention must be paid to details in construction, water leakage is leakage at the corners and pipe roots, and large areas generally do not leak.

It is still strongly recommended that the bathroom should not be painted, even if it is the kind of exterior wall paint, but because the bathroom has been disturbed by water vapor for a long time and is excessively humid, it will not take long and it is still easy to fall off. It really needs to be done, it is best to buy a shower room, put the shower room wall or tiled, and paint the wall in other places to distinguish dry and wet. But it will still keep the paint on the walls for not too long.

with waterproof paint or exterior paint.

Is there any paint in the bathroom? Doesn't the moisture go away?