Why can t the temperature of the shower water in my house go up, and the temperature difference betw

Updated on Kitchen 2024-08-22
4 answers
  1. Anonymous users2024-01-24

    There are 8L, 10L, 13L and so on, the larger the number of liters, the more water supply per minute, it may be that your water heater is not big enough. I have a 10L home with a distance of 7M from the water heater to the bathroom sprinkler, a total of 5 gears, and I feel that the water is too hot when I turn on the 3rd gear

  2. Anonymous users2024-01-23

    Aren't your kitchen and bathroom together?

    More than ten meters of pipes are too long and easy to lose heat. You can also buy that kind of insulated pipe and pay a little more.

  3. Anonymous users2024-01-22

    It should be the same water pipe, and the water valve must be closed after the shower, otherwise it will be on the cold water!

  4. Anonymous users2024-01-21

    It may be that the insulation of the water pipe is not done well

Related questions
2 answers2024-08-22

You can find a professional plumber to show you what went wrong, and let him repair it for you.

1 answers2024-08-22

The pipes are connected in series, right? This is normal for a single tube to be connected in series.

1 answers2024-08-22

Why can't I get in the ranch and restaurant, the farm is in, the ranch and the restaurant can't get in, so please empty the ie garbage. The steps are as follows: >>>More

2 answers2024-08-22

This may be due to the fact that the joint of the line that entered the kitchen during the original installation was not tightened, and the copper core wire of the new line was not oxidized at first, but after a long time, the contact was not good due to the oxidation of the surface of the wire with a long temperature, and the operation would occur. It is recommended to find the location of the junction box of the joint, whether the discharge sound and ignition can be heard when the light is turned on after powering on (like the discharge sound of the welding machine), and then after the power is off, polish the joint, tighten the joint, put on the tin, and wrap it tightly with electrician black insulating tape.

2 answers2024-08-22

The small piece of tempered glass is standard, and the fine powder is the edge of the tempered glass, and the edge is caused by different pressures when the air press is tempered, and the one you describe belongs to the qualified product!