-
Anonymous users2024-01-24First of all, remove a piece of the gusset next to the lamp (with a suction cup or a sticky hook), then remove the lampshade, and then press the tube of the same model.
Finally, press the lampshade and the removed gusset.
Precautions: 1. Take lightly, do not use too much force, otherwise the lampshade and gusset are easy to deform; 2. Remember the original installation direction, it is easy to produce color difference when pressed backwards.
The bulbs that make up the ceiling are not produced by the ceiling manufacturer. It's all OEM. That is, it is commissioned to produce by a bulb manufacturer.
When you replace it, try to choose a well-known brand bulb, which is more thermally efficient and safer. .Use a professional suction cup to suck off the panel of the lighting module, and change the lamp tube!
But you have to find a professional to do it! Remove the plate adjacent to the lamp, lift the lamp, or move it to the other side of the board, and replace the bulb or board. Generally, it is who gives the installation and who changes it.
The integrated ceiling has a series of lamps, his lamp is composed of two parts of the mask and the top seat, there is a special suction cup, if not, you can also use the kind of thing that hangs clothes to suck on the wall, suck the mask down, and then change the lamp, the lamp tube is buckled by the buckle, and it is easy to take it down!
No matter what complex ceiling lamp, it is divided into the bottom and the mask, your lamp is no exception, the mask is fixed on the base, and then buckle up, and then there is a card bar on the base, just like the photo frame, you put your hand on it, touch the card bar on which side, generally there is one on all four sides, after touching the card bar, dial it, to see which side can move, which side is open, after a few are dialed, you can take off the mask, in fact, it is very simple. Ceiling lights, no matter how complicated they look, rely on clipsticks to hold the mask in place. The crystal lamp is called difficult to install.
The most convenient disassembly is to remove the aluminum gusset next to it, and then the lamp is much easier to dismantle, and only a small thin blade is needed to remove the aluminum gusset.
If the brick surface is cracked, use a cutting machine to cut along the diagonal, be careful not to reach the four corners, and then smash it from the middle, scrape off the grout between the brick joints, and then carefully pry the tiles from the middle to the surrounding sides, basically will not affect the surrounding tiles, clean up the base layer, and re-pave the new tiles. >>>More
It is also possible to pull out a wire from the wall switch and connect it directly to the line of the ceiling light, but even the original switch cannot control the kitchen ceiling to connect to the light. Wherever the switch is connected, it is the switch control. >>>More
You're talking about the built-in light with the integrated ceiling is broken, right? Does the merchant promise a warranty for several years? If it's still under warranty, just call it.