-
Anonymous users2024-01-241. Pay-off.
According to the floor elevation level, according to the design elevation, along the wall around the ceiling elevation level, and find out the center point of the room, and along the elevation line of the ceiling, with the center point of the room as the center on the wall to draw the keel binning position line.
2. Install the main keel boom.
After springing the ceiling elevation level line and keel position line, determine the elevation of the lower end of the boom, install the pre-processed boom, and the boom installation is fixed on the ceiling with a diameter 8 expansion bolt. The boom is made of 8 round steel with a diameter, and the spacing of the boom is controlled within the range of 1200.
3. Install the main meridian bone.
The main keel is generally C38 light steel keel, and the spacing is controlled within the range of 1200. When installing, the hanging parts matched with the main keel are used to connect with the boom.
4. Install the side keel.
According to the ceiling net height requirements around the wall with cement nails fixed 25 25 paint keel, cement nail spacing is not more than 300.
5. Install the secondary keel.
According to the specifications and dimensions of the aluminum ceiling, the secondary keel matched with the plate is installed, and the secondary keel is hung on the main keel through the hanging piece. When the length of the secondary keel needs to be extended by multiple continuations, the secondary keel connector is used to connect the opposite ends while hanging the secondary keel, and is straightened and then fixed.
6. Install the metal plate.
When the aluminum ceiling is installed, pull a reference line in the direction of the vertical secondary keel in the middle of the assembly area, and align the baseline to install on both sides. When installing, handle it gently, and you must press both sides of the square plate lightly in the order of the flanging part, and then push it tightly after being stuck into the keel.
7. Clean up. After the aluminum ceiling is installed, the board surface should be wiped clean with a cloth, and there should be no dirt and handprints.
8. The following documents and records should be checked during the acceptance of the ceiling project.
1) Construction drawings, design descriptions and other design documents of the ceiling project;
2) Product qualification certificate, performance test report, entry acceptance record and re-inspection report of the material;
3) Concealed project acceptance records;
4) Construction records.
Aluminum square pass (U-shaped square pass, U-shaped groove) is one of the ceiling materials produced in recent years, aluminum square pass has an open vision, ventilation, breathability, its lines are bright and neat, the hierarchy is clear, embodies the simple and clear modern style, simple and convenient installation and disassembly, has become the main product of the decoration market in recent years.
It depends on how big the size of the square pass you use? Fangtong is generally used with special clamp bones and booms.
In order to facilitate production and transportation, the length of the aluminum square pass ceiling is generally 6 meters. Beyond 6 meters, it is inconvenient to pass the furnace, and beyond 6 meters, the cost price will be relatively high, so it is not recommended to exceed 6 meters.
Usually the manufacturer does the longest six meters, if the eight meters are made into four meters, the middle can be connected with a joint, the U-shaped square is generally fixed with a windproof bone, and the aluminum side of the profile is a hanging piece
OK. 1. LED lights can be embedded between the aluminum square pass and the aluminum square pass. 2. The aluminum square can be slotted and put the LED in.
1. You can choose a built-in lamp with a suitable color, 2. Match a beautiful ceiling lamp. >>>More