-
Anonymous users2024-01-24Do waterproofing needs to be done on the surface of the water, dig excellent permeability crystalline waterproofing, you can do it yourself on the cement surface with a super permeable waterproof guard (if there are cracks and potholes on the cement surface, fill the complete with metin porcelain glue and then do waterproofing).
For the tile surface, first check whether the filling of the tile gap is complete (if the filling of the tile gap is incomplete, fill it with Meiding porcelain glue, and then use a stone tile waterproof guard to do waterproofing).
Exterior wall paint can be made waterproof with transparent waterproof repair adhesive.
The product will penetrate into the base layer and make the base layer waterproof. The product is recommended to be constructed in a dry place, the drier the base surface, the deeper the product can penetrate, if the base surface is full of moisture, high density, the material can not penetrate well. Regarding the principle of waterproof plugging, the source of water leakage is not blocked, and the water will only continue to penetrate into the wall, which will exist inside the wall for a long time, and will leak out from other parts of the wall when the water reaches a certain level.
The problem cannot be solved, and only by spraying waterproofing agent on the outside of the roof or exterior wall so that the water cannot penetrate into the wall and flow away can the problem be completely solved.
It mainly depends on what type of floor drain Generally, the digging floor drain will destroy the waterproofing So after doing a good job, you need to do the waterproofing near the floor drain, and the ordinary pipe plug-in floor drain is not allowed. . . .
1. Ground leveling.
The first thing to do is to level, use cement cementitious materials to operate, and only after the level is qualified can the next step be started, so as to prevent the leakage caused by the uneven thickness of the waterproof coating. >>>More
Waterproofing of the bathroom is a must be done, and it is a very important process, waterproof construction should be waterproofed with a coating film, the performance of waterproof materials should meet the provisions of the current national standards, and there should be a product qualification certificate; The surface of the base should be smooth, and there should be no defects such as hollowing, sanding, cracking, etc., and the moisture content of the base should meet the construction requirements of waterproof materials; The water pipe on the ground should be re-routed, the current water pipe should go to the top surface, the ground is made of cement mortar and then painted with waterproof coating, the waterproof layer should extend from the ground to the wall, 250MM higher than the ground, and the height of the waterproof layer of the bathroom by the shower head wall shall not be less than 1800MM; THE WATERPROOF LAYER OF THE COATING FILM IS EVENLY BRUSHED, THE GENERAL THICKNESS SHALL NOT BE LESS THAN 1 5MM, THE WATERPROOF SURFACE OF THE COATING FILM IS NOT BLISTERED, DOES NOT FLOW, IS SMOOTH AND HAS NO CONCAVE AND CONVEX, AND THE JOINTS OF THE PIPE FITTINGS, SANITARY WARE FEET, FLOOR DRAINS, AND DRAINAGE OUTLETS ARE TIGHTLY CLOSED, AND THE WATERPROOF PROJECT MUST BE COMPLETED FOR 24 HOURS WATER STORAGE EXPERIMENT.
Do waterproofing needs to be done on the surface of the water, dig excellent permeability crystalline waterproofing, you can do it yourself on the cement surface with a super permeable waterproof guard (if there are cracks and potholes on the cement surface, fill the complete with metin porcelain glue and then do waterproofing). >>>More
So what else can I do, knock it off and re-pave it! Or prepare a broom with plastic wool and sweep it to the floor drain after use. There is another way, where there is more water to cut to the groove to the floor drain, the groove should not be deep, at most 1cm, will not damage the waterproof layer, it is so ugly.