-
The centerline was calculated with a ruler and marked with chalk.
-
There is only one kind of annotation for the center line, and the center line type is used, and since it is the center line, it must be symmetrical.
1. Supporting furniture software should be powerful.
2. The production capacity should be balanced and distributed. >>>More
It is not complicated to change the time to piecework, after the core of the problem is changed, the single price should be set reasonably (set high, the company spends more money, and the employee resists the low), but at least the result of piecework is to improve the labor enthusiasm and production efficiency of employees, after the employee accepts, the salary of skilled and diligent employees will definitely be higher than before. Steps: >>>More
There is an edge banding machine.
The principle of the machine is that the PVC to be edge-banded is overheated, and then pasted to the part that needs to be edge-banded. >>>More
Jinan production engraving machine manufacturers less than two or three hundred, large manufacturers and big brands to Jinan Gete, Jinan local users, standardized production, large output, can go to Jinan furniture factory to see the actual processing effect. >>>More
These materials can be downloaded on the Internet, the plane is more to indicate what things are placed where, if it is a construction drawing, it should be determined according to the size of the site, and then ask the owner if he is optimistic about the material, you can also suggest that the basic material in the figure pin seepage has a size.