There is a load bearing beam in the middle of the living room of the newly bought house 57 cm high,

Updated on Living room 2024-08-27
3 answers
  1. Anonymous users2024-01-24

    From the surface 2-5 cm is the rebar, so there is no room for planing.

  2. Anonymous users2024-01-23

    If you can't go, it will affect the overall structure. If you go too much, the two ends of the beam will be subjected to excessive force, which may lead to the upper plate line marks and water leakage. It can also be more severe. Affect the decoration can find a way to cover, or simply not so high. Remember, that's the girder.

  3. Anonymous users2024-01-22

    Absolutely not moving. Without the knowledge of the neighbors and the property. It can only remove the surface cement of the sorghum. Just leak out the rebar. It would be very dangerous to knock all the beams off.

Related questions
There is a load-bearing beam in the middle of the living room in the north-south direction, how to d
4 answers2024-08-27

The beam is deeper, if it is unlikely to be fully hung flat, it will appear that the height of the floor is too short, you can distinguish your position on the top according to the specific position of your furniture, after the position is determined, then see the position of your beam in the position of the top of the differentiated. Then do a partial ceiling modification, try to make some fuss on both sides of the beam, so that the beam looks less prominent.

There is a load-bearing beam on the balcony of the house, what should I do with it
3 answers2024-08-27

You're talking about a load-bearing beam on the top of your balcony, right? If so; Tell you that the load-bearing beams are supporting all the weight of your upstairs balcony and will never be able to handle it. If you need to hang the balcony ceiling 1 >>>More

There are no load-bearing beams in the living room, only there are shear walls around it, 7 5m long
1 answers2024-08-27

It is recommended that you look at the given value of the original design for the slab load before renovation, if the slab load exceeds the allowable load capacity, it is unsafe. In order to ensure safety, you can also ask the original design unit of the house to help calculate the safety factor.

Decoration problem to solve the living room load-bearing beam method
5 answers2024-08-27

Living room load-bearing beam decoration method:

Make an S-shaped ceiling or irregular ceiling based on the beam, and add tinted glass to the inner soil line lamp. The edges of the focus should not be too thick. Plainly. >>>More

Is it OK to use a lightweight brick partition wall where there are no load-bearing beams in the livi
1 answers2024-08-27

The partition wall can be played in the place where there is no load-bearing wall beam, but the lighter the material, the safer it is, such as wooden keel plus gypsum board, plus composite board, and light bricks for the city. But the diaphragm is poor.