-
Anonymous users2024-01-24Of course it's not good... Normally, the keel should be 400mm in one section, and the three-section keel fixes a whole gypsum board (1200mm), so the gypsum board joints should be in one of the best, but the length of some rooms is not enough to divide 1200mm, so one or two more seams are also divisible.
Hope it helps you, hope.
-
Anonymous users2024-01-23In general, it is basically decorated by the keel.
Hello, this is the common sense of decoration, the joints of the gypsum board must be on the top of the secondary keel, so that the gypsum screws can be better fixed, so that the interface will not be cracked after scraping the putty powder.
At the joints of the gypsum board of the ceiling, it is better to use the grid bag than the seam paper, because the toughness of the grid bag is higher than the seam paper, so the seam paper is easy to rib, and the grid bag is not easy to rib.
Laying direction, fixed transversely and longitudinally.
The strength performance and deformation of gypsum board are determined according to the direction, and the longitudinal performance of the board is superior to the transverse, so the longitudinal part of the gypsum board is not allowed to be parallel to the covered keel when the ceiling is suspended, and it should be perpendicular to the keel, which is an important measure to prevent deformation and cracking of joints. >>>More
Mix white latex or polyethylene glue with gypsum powder, but now there are anti-cracking products on the market that do not need to be adjusted, but the price is relatively high. And the effect is not as good as gypsum powder, fill the gap after adjusting evenly, and then paste gauze tape on the outside (kraft paper is better than gauze tape, there is a new type of fiberglass mesh belt), and then scrape putty.
Generally, kraft paper is scraped on it with white glue. When you do it, you will batch putty.