-
Anonymous users2024-01-24The waterproofing of the wall of each bathroom should be about 2 meters, which has no effect on tiling.
It's best to find a level, as long as there is a pit, there is a possibility of uninsurance, such as in order to save such a little thing, the gains will outweigh the losses. Waterproof is like that, if you don't follow the steps it will really give you a good look haha.
If it is JS material, you need to wait for 48 hours, if the coil is done, wait until the wall is white, and the four walls, the ground, and the elevation of 50 are enough, and you need to carry out the water avoidance test before you can paste the brick, and the water depth is 25! It is recommended to add plugging agent to JS material and brush it three times, with an interval of 15 minutes between each time!
It's relatively easy to do it yourself.
First: ground leveling is the uneven place needs to be leveled, so as to save the amount of waterproof mortar and ensure waterproofing. >>>More
As long as an interface agent is used on the waterproofing layer, this cannot happen. What's more, after the tile is paved, each piece is restrained by each other, the lower part is supported by the ground, and the back is bonded with cement mortar, and it is impossible to collapse. >>>More
If it is water-based, it will not affect the tiling, such as: K11 waterproof slurry, mortar waterproofing agent, etc. >>>More