-
Anonymous users2024-01-24The waterproof shower wall in the kitchen and bathroom is metered, and the non-shower wall is metered, but in order to strengthen the waterproof effect, we all achieve the meter height, and the cost does not increase much. It is generally recommended that the kitchen floor and wall are turned over for waterproofing, and it is best to turn over the meters on the wall where the washing basin is placed to set up a waterproof layer.
How to calculate the waterproof area in home renovation?
Waterproof area of toilet and bathroom (square meters) = floor perimeter of toilet and bathroom - width of the door meter (height) + (floor area).
Kitchen waterproof area (square meters) = kitchen floor perimeter - width of the door meters (height) + (floor area).
Family decoration, hydropower reform first, after the completion of hydropower transformation, immediately to do waterproofing. It should be noted that waterproofing should be done as much as possible at the base layer of the structure.
-
Anonymous users2024-01-23The area of a certain wall is calculated using the corresponding length and width. If the size of the entire room is required, it should be twice the length, width and height.
-
Anonymous users2024-01-22Should the area of the bathroom be counted as the top?
Top area = bottom area = length x width;
Side area = (length x height + width x height) X2
The circumference can be added by length, width and height, and you can add which lengths depending on the circumference you need.
-
Anonymous users2024-01-21Top area = bottom area = length x width;
Side area = (length x height + width x height) X2
It is recommended that you install a gas water heater next door to the kitchen and bathroom, and install an electric water heater next door, so that the choice is mainly based on the short connection of the hot water pipe, less pre-discharge of cold water when using, and it is convenient to adjust the temperature.
It's all a layer of gold... That's it. There is no other way、。。 Nothing else. You can get it. Words for this thing. That's what it means.
In view of the fact that your tile is a bit big, it is not recommended to use a flexible waterproof coating, and you can use Oak K11 general waterproof coating. It is a rigid waterproof coating, which will not be pulled off by the tiles or cause hollowing.
If you don't do waterproofing when you decorate, you need to consider the waterproofing of the bathroom, so you need to smash the tiles on the wall to do the waterproofing of the wall! (rice waterproof) and then carry out re-tiling, no directly on the tile to do waterproof!
It's no problem to stick the tile, and if it doesn't leak at the time, it generally won't leak. >>>More