-
Anonymous users2024-01-241. Installation of flush toilet sewage pipes.
1. The toilet sewage pipe should be made of plastic pipes required by national standards, and the inner wall of the pipe should be smooth, flat, no bubbles, no cracks, no obvious marks and depressions.
2. The pipe in the toilet has been set with a deodorant water seal, so there is no need to set up a water trap on the sewage pipe, otherwise it will affect the flushing function of the toilet.
3. When the sewage connection horizontal pipe is connected with the riser, it is advisable to use a 45-degree oblique tee to connect with the water.
Second, the toilet installation steps.
1. Determine the installation position, drill holes in the ground, align the ground sewage nozzle with the sewage outlet at the bottom of the toilet bowl, draw the position of the fixed hole at the bottom corner of the toilet on the ground according to the peripheral size of the toilet base, and punch the hole with a percussion drill. The depth of the eyelets is about 5 cm.
2. Install the toilet base.
Hammer the steel expansion bolt into the ground drill, put the expansion bolt into the bottom corner of the toilet bowl and tighten the nut to put the toilet in place. The toilet drain outlet should be tightly connected with the preset sewage pipe on the ground and sealed.
3. Install the water tank (this step is not required for the one-piece flush toilet).
According to the installation height of the water tank and the position of the hole on the back wall of the water tank, drill the hole in the corresponding fixed position on the wall and knock in the steel expansion bolt, then put the water tank in place, make the hole on the back wall sleeve into the expansion bolt, add a 3 mm thick nylon washer and put the nut on it and tighten it.
-
Anonymous users2024-01-23Of course. You've taken into account the issue of odor prevention. At present, the so-called anti-odor floor drain on the market is not effective, so take a plastic bag on the floor drain of the shower to fill it with water, and take it away when you use it.
Use a toilet cleaner bubble like Mighty and brush it off with a brush, and the most likely place for bacteria to grow in the toilet bowl is recommended to be cleaned with toilet cleaner in two or three days.
Because the paper is clogged and can't be flushed out, it comes out of the ventilation hole, and my family too, I regret installing this!
If the aperture of the bottom of the toilet is equal to the distance between the toilet outlet and the wall, and the error is not more than 3 cm, you can use the rubber sealing ring attached to the toilet purchase, and then glue the bottom of the toilet with glass glue.
The reason for your toilet leakage is likely to be that the toilet is not installed properly--- the pit injection is not aligned, or there is a situation that the toilet has two puddles Note 30-40, one of which is not used The pit injection is not sealed in the leakage, because the toilet is equipped with a flange, so it can't leak into the sewer pipe, and it overflows. It has nothing to do with the pipeline you talked about.
These two small holes are indeed used to fix the toilet, but now many people use cement mortar to fix the toilet when they install it, so the small holes are useless, and you can ask the installer to block the small holes with white cement.