-
Anonymous users2024-01-24Hello, there are several reasons, 1, the water may be blocked. 2. There is dirt on the inside of the toilet.
When it's new, you can't do it
No, it won't.
Poke it with a tool, and it's a slight blockage from underneath. >>>More
Flush toilet drains slowly and has no suction: 1. The amount of water in the water tank is small, and the length of the pressure rod changes, which causes the water stop pad to be reset quickly to stop the water, and the length of the pressure bar can be adjusted to a suitable one. >>>More
1. Accessories are damaged.
The toilet flushes slowly and does not whirlpool, which may be caused by the lack of water in the toilet tank, and the most common situation is that the accessories are loose or damaged. It is recommended to open the water tank, tighten and replace the corresponding accessories, and the problem can be easily solved. >>>More
I judge that the sewage pipe under your toilet is with an S bend, the toilet is relatively sealed after installation, the toilet has its own S bend, and the water is relatively slow when the two S bends are drained due to the internal air pressure, and it is recommended to install a vent pipe in the place where the toilet and the ground are linked, so that the internal air pressure is reduced, so that the drainage is smooth, but there is a disadvantage that it is easy to return to the smell. Some toilets have holes for installing screws on the base, and these two holes should not be sealed when installing, which will also have an effect.