-
Anonymous users2024-01-24Under normal circumstances, any flush toilet, 4-5 years of use will be fouled, the original smooth ceramic surface of the fouling, it seriously affects the drainage capacity of the toilet, resulting in the inability to flush in time, slow drainage, which is usually caused in the process of use, generally the only longer way to appear this phenomenon is to replace the toilet, even if it is descaled in various ways, the siphon elbow inside the toilet can not be completely removed, there is a temporary improvement, and this phenomenon will still appear after a while.
First of all, it is forbidden to urinate in the toilet, even if it is necessary or unavoidable, it is necessary to flush out the urine in time, do not be afraid of water, and secondly, you should not throw the paper into it after unraveling it; In addition, there is a subsection on the installation, that is, the toilet outlet must leave a certain amount of water, if after flushing, the toilet outlet is always only a little bit of water left, and even the outlet has not overflowed, so that when used, it will be directly stained with dirt on the ceramic surface, which is extremely unhygienic and troublesome.
As long as you pay attention to the following points, it can be used for more than 10 years or more, except for general wearing parts.
Urinate frequently. Don't throw away paper sheets.
Wash frequently, but do not use sulfate hydrochloric acid, which will directly lead to damage to the ceramic surface.
-
Anonymous users2024-01-23Maybe the sewer pipe is a little blocked, and now many toilets are using jet siphon method, resulting in a problem with the air pressure difference, and the power of the siphon is insufficient.
-
Anonymous users2024-01-22At present, the material of the toilet is basically acrylic and ceramic.
The biggest disadvantage of the ceramic toilet is that it has about the water absorption rate, and then the increase in the use time will produce scale and cause blockage, it is recommended that you find a professional or use a dredging tool to dredge it, this is simple.
-
Anonymous users2024-01-21It may be that there is water alkali, and it will be better to clear the water alkali at the outlet, so try it! It's the same as the shower head.
-
Anonymous users2024-01-20It must be blocked there, and the flush is not fast when it is blocked below.
-
Anonymous users2024-01-19Open the lid and take a look, there may be a problem with the switch.
There is a local blockage, which can be dredged with Snow Leopard brand pipe dredging agent, which has a very good effect and can also remove dirt.
The main reason for this situation is the low water level of the toilet, you turn the water level in the tank higher, increase the amount of water, so that the gravity of the water increases, so that it can be flushed smoothly at one time.
Of course, you can live in many rental houses in Beijing, Shanghai and Guangzhou, and the bathroom is changed into a small bedroom.
In fact, it is not controlled by light, but by the induction of the human body, just like the induction switch of an electric light, the only difference is the difference between the control of electricity and water.
It is recommended that you run a few more places when changing the toilet and take a look at it, there are now some toilets that use very little water and have a good effect. Environmental protection, saving and beauty are the only way to do it.