What s going on with the new toilet bowl that just pressed has no suction. When installing. There s

You'll have to look at what the reason is.

There are generally several reasons for this: >>>More

Flush toilet drains slowly and has no suction: 1. The amount of water in the water tank is small, and the length of the pressure rod changes, which causes the water stop pad to be reset quickly to stop the water, and the length of the pressure rod can be adjusted to the appropriate one. >>>More

Try it with toilet cleaner or alcohol. It should be wipe-off. It is recommended that you pay attention to regularly ventilating and dehumidifying the toilet or washroom and turning on the exhaust fan, which can greatly reduce the signs of mold.

There may be three conditions that cause no water:

1. The water level of the water tank is high enough, and the flushing is not smooth, which is caused by air pressure. Check that the 2 side screw holes at the bottom of the toilet bowl are sealed. There must be some seams. >>>More

You can use a large mineral water bottle to cut off the bottom of the bottle mouth to the halfway point of the bottle, and then poke it down a few times, or use a small bucket of hot water to flush it quickly at the toilet mouth, which should be dredged.