How to deal with the thick and short floor drain of the brick and sand ash layer on the floor of the

First of all, it is necessary to do waterproofing, closed water detection to ensure that there is no leakage, and then pave the wall tiles, and finally pave the floor tiles. Then start laying wall tiles, and finally determine the slope of the floor tiles according to the position of the floor drain, and start laying the floor tiles. It is necessary to ensure that the floor tiles can not accumulate water after they are paved, and the floor tiles must be tested with a basin to determine that there is no water accumulation at all and the drainage is smooth.

The tile is beige Then the floor tile is recommended to choose a warm color, the color can not be too dull, it is recommended to use a greenish color, but it must be light green in a little yellow, and the light green feeling is also crisp, but not obvious, must be in line with the warm green. Pink is not recommended to be used, and the bathroom is not good looking when the ground is red.

Clean the ground first, plug the leak, fill the water, make a horizontal mark on the wall, and make a satisfactory angle radiation with the horizontal mark at the corner of the wall. Please have the original method of tiling tiles with a level: laser level - purchase - measure - level mark - to make a satisfactory angle radiation with the horizontal mark of the corner of the wall. >>>More

Wet paste... My uncle is in the decoratives.

Generally speaking. The floor tiles of the bathroom, he should not have a gap, otherwise this joint is not tight. It's easy to leak.