Can you fix a phone if it falls into the toilet

If the phone falls into the toilet, the first step is to immediately end the current "work" and see if it is completely submerged in the yellow soup of the toilet. If you feel dirty, just wrap your hand in a plastic bag or tissue and pick it up.

If it is completely immersed in the yellow soup, put a disposable glove or plastic bag on your hand and pick it up.

The following is a cross-sectional diagram of the toilet squatting position, whether it is squatting or sitting, the principle is similar.

After the mobile phone is scooped up, whether it is submerged in the yellow soup or not, do not turn it on, because the opening will be short-circuited instantly, causing the mobile phone to be completely unrepairable. You can't rush to wipe the water on your phone, because the most important thing right now is not this matter.

The most important thing now is to open the back cover immediately and remove the battery to prevent a short circuit.

After the battery is removed, you can dry the water with a cloth or paper towel and shake the water dry.

If you have a hair dryer, you should turn on the hair dryer and dry it with regular air, remembering not to use hot air.

After the above is done, put it in a ventilated and dry place as soon as possible, remember not to put the battery in, and then turn it on after 24 hours, and you can't try to turn it on halfway.

If it doesn't turn on after 24 hours, you should take it to a professional as soon as possible and tell them about your situation and the steps you have taken.

See if there is any water inside, and then turn it on after drying.

Answer 1: Water ingress and crashing are the two taboos of mobile phone use, and water ingress of mobile phones is particularly serious. According to an engineer from Guoxin, after the mobile phone gets into the water, the first thing to do is to turn off the power, of course, not to press the shutdown button, but to remove the battery. Because as soon as you press the shutdown button, the mobile phone will be powered on, and it is likely that a short circuit will occur, causing damage to the mobile phone, and then send it for repair as soon as possible.

If your phone's warranty has expired and you don't want to send it for repair, you can boldly take it apart! Wipe the parts of the phone with a tissue, and then blow it with a hair dryer for a few minutes, in order to ensure that all the internal parts are dry, it is advisable to air dry the phone for a few more days before you can turn it on again.

2. Once the mobile phone is flooded, the battery should be removed immediately, and the mobile phone must not be turned on immediately to understand the condition of the mobile phone. After removing the battery, do not use a hair dryer to deal with it, and immediately send it to the repair professional to disassemble the machine for water treatment, such as falling into sewage or corrosive liquid, and use ultrasonic cleaning and drying before proceeding to the next step of maintenance. If the mobile phone can still be used after water penetration, it should be sent to a professional to deal with it to avoid corrosion of the circuit board and make it impossible to repair.

3. No matter what kind of water the mobile phone falls into, the mobile phone battery should be removed first, and the mobile phone should not be recharged again. If it falls into clean water, remove the battery and clean the phone with anhydrous alcohol, because the alcohol volatilizes quickly, and the water on the circuit board can be volatilized together. Then use a heat gun or hair dryer to dry the circuit board, and then power up the test machine, and most mobile phones will work normally.

If it falls into the sewage, it should be cleaned immediately, and the dirt that can be seen should be cleaned first. Use a brush to brush off the impurities attached to the pins of the components. Then, the circuit board is scrubbed with an alcohol cotton ball, and if the pollution is serious, the impurities must be vibrated out with the help of an ultrasonic washing instrument.

Then use an air gun to dry the circuit board, and then repair all the chips.