-
Anonymous users2024-01-24The person squats down against the wall at least 20 centimeters on one side. A brick behind the buttocks is 30 cm. Too small a butt will hit the tank.
-
Anonymous users2024-01-23The middle line of the back partition wall to the pipe is 55 centimeters next to the partition wall to the middle line of the pipe 40 cm, which is the standard! You can also add or subtract a little!
-
Anonymous users2024-01-22You can't just give it a try.
The bathroom squatting bedpan is installed as follows:
1. At the sewage outlet of the installed product, reserve the sewer pipe at the appropriate position from the wall, and determine the distance between the inlet of the sewer pipe and the ground level. >>>More
It is recommended to use a toilet, so that the ground elevation size can be controlled within 15, and the minimum squatting is 30.
I'm in the installation of hydropower, and I think it's better to have the outfall on the right. This is because the instantaneous pressure of the flush valve can be used to flush the dirt.
In your case, it should be that the embedded water pipe inside the wall is damaged, or the internal wall of the bathroom has a wash basin, mop basin and other places where water is leaking, resulting in the wall being wet for a long time and then appearing outside. Check them one by one, repair and manage.
First, use a manometer to measure the water pressure and see if there is any leakage in the water pipe. If a water leak is ruled out. It may be a problem with hot and cold pipes, and the cost of relaying pipes is too great, so it is better to stick two pieces of porcelain at the water seepage.