The toilet of the new house is only 2 1m high, and the solution to the ceiling is sought

Amazing new house. Since I bought them all, I can only admit it, and now I can only solve it. The upstairs floor slab must not be hit, that is, the sinking of the upstairs toilet, that is, the pipe of the toilet needs so much and the sinking waterproof effect.

It is impossible to hang the top of 10-15mm downstairs, unless your pipeline goes to the wall, which is very expensive. The headroom (minus 50mm ceiling lines, 15mm ceilings, and 40mm floor tiles) can only be done by 2 meters now. I saw that there is no beam in this bathroom, and it can also be tiled on 6 sides so beautiful and beautiful, and the height and price are reasonable The bath bomb can be installed on the side.

This general ceiling cannot be removed.

You can measure carefully, and if it is lower, you can claim for violating the building design code.

And according to the specification, the space below can be halved to calculate the construction area.

Bath bombs can be installed on side walls.

You can find a way to lower the height of the ground a little more. But your photos are not comprehensive, and it is not certain whether this can be done, but it is certain that smallpox cannot be removed.

The top is the cast-in-place board Where is the 50 cm wall, your house is really a chicken rib, the general house floor height is, we decorate the toilet after hanging the ceiling has to be left high, your squat is installed, the bottom should be able to play, you can play the following, try to install the squat at the low point below a hurdle, the upper integrated ceiling is not high, hang 10 to 15 down on the line, buy that kind of warm air bath bomb.

Inside the concrete is the drain of the toilet, the drain of the floor, and the drain of the washbasin, so it is recommended to let the mechanic smash it slowly and avoid the position of the water pipe.

Why is it so low, the standard is 2.4 meters. At this height, the overhead shower water has just come out.