The phone fell into the toilet and hit it in about 10 seconds.

1 Remove the battery.

2 It cannot be turned on from the new battery, and it must be dried.

3 Use a hot blow dryer to blow the phone at a medium temperature test at a distance that is not hot, estimated for half an hour. The back cover of the phone must be opened during this process.

4 Use a cold air to blow air into the board as much as possible on the back of the phone (to remove the moisture inside).

5 Wait until the phone is completely cool, and then repeat the above action.

Now it's absolutely OK to install the battery.

6 Pay attention to the water in the screen, be patient, blow slowly, the temperature is lower than blowing the motherboard, because the LCD screen is afraid of heat.

Shut down immediately.

Open (take it apart) to see if there is any water inside.

Remove the ingress water.

Then go for overhaul, this degree is not good.

Another experience to share: Generally, after taking out the mobile phone that fell into the water, remove the battery, card, etc., wipe it dry one by one with facial paper, and you can't use a hair dryer, which will blow the water to a more internal position, and the hot air will also make the mobile phone quickly increase the heat, which will cause more damage to the mobile phone. After wiping dry, put it in a ventilated place, and turn it on again for about 10 days.

Your mobile phone is no longer usable, and the circuit board only burns when it encounters water, so it's better to buy a new one.

You should take a look at the water, if there is water, put it in the sealing tape, put it in the rice, you take it to repair, it will be repaired, I fell into my hand last time, just go and fix it.

If it can be repaired, it can be repaired for 50 quick money.

Take the battery off, remove the card, take the phone apart, dry it for a few days, and put it on it.