-
Anonymous users2024-01-24I've had this issue as well.
The case is a Z-shaped corridor with different widths. The treatment I did was to make the light pool on both sides, keeping the same size in the middle.
In this way, when the light is turned on, the light will weaken the sides and highlight the middle. The visuals are relatively complete.
The size of the ceiling should be 20 cm high from the wall point, 30 or 35 wide from the wall, there are a few 40 cm light trough, the width of the outer baffle is generally about 8 cm, the width of the light trough is 10 cm or 12 cm, it is generally determined according to the width of the entire ceiling, if the ceiling height is high, the high fork will be larger, and the height of the ceiling will be smaller than that of the low ceiling.
This should be the sprinkler head on the ceiling surface, unless the ceiling surface is uneven, this is okay.
As shown in the figure above, the false beam is divided into areas where it is needed, and then the size and width of the side ceiling are set to complete the living room ceiling of different widths. . . >>>More
There is a difference between the integrated ceiling and the large slab ceiling, the integrated ceiling is 300 300 or 600 600 integrated plates can be assembled at will, while the large slab ceiling is a molding can not be disassembled.
The installation dimensions of the integrated ceiling bath bomb mainly include the following aspects:1Ceiling size: >>>More