-
Anonymous users2024-01-24If only a few pieces appear loose and bulging, then it is recommended to use tile adhesive to carry out local repairs according to the following methods:
1.First, clean the cement where the tiles fall off to expose the cement base.
2.Pour the porcelain sticker powder into water and stir it into a paste (the mixing ratio is: 20kg powder and 6kg water), and after stirring, it needs to stand still for about 10 minutes, and then stir slightly before use, which helps to increase the adhesion force.
3.Use porcelain tile adhesive to repair and level the peeling cement base first, and then evenly apply the tile adhesive to the back of the tile.
4.Knead the tiles to the point where they originally fell off.
5.Finally, gently tap the tile with a rubber hammer so that it is the same height as the other tiles.
However, if the area of the hollow drum is loose, then in order to fundamentally solve the problem, it is recommended to re-attach all of them.
-
Anonymous users2024-01-23Solution:
1. Prepare tile caulk.
2. First press the upper end of the silicone gun, then pull the lever up to the top, and put the caulk into the silicone gun.
3. Before caulking the tiles, the gaps of the tiles should be cleaned, and there should be no water in the gaps.
4. Fill the gap along the tile, and try to make the caulk evenly fill the gap in a continuous straight line.
5. Put on the finger cuff and slide your fingers along the extruded caulk.
6. Wait for about a minute, and then you can easily scrape away the extruded remaining material with a blade.
The caulk will solidify after hours and will completely solidify and harden after 24 hours.
8. Done.
Support sctmy! Articulation by carpenters.
Is the gate (or pass) set? If it is not decided, it can be connected by the door sleeve board (or pass), which is commonly known as "woodworking technology". With the advancement of technology and materials, woodworking is no longer the traditional definition, and the projects completed by traditional craftsmanship can be collectively called "carpentry". >>>More
Yes, the separation of wet and dry is only functional, and it is only necessary to separate the bathroom into two areas, and the floor is not affected. >>>More
It is okay to hook the tiles on the bathroom floor that have just been pasted.
This is the slope of the ground has not been dealt with, there is no better way, can only rework, re-process the slope of the base, according to the slope of the floor tiles, really in to help you look forward to adopting,
If there is an agreement first, and the mistake is the other party, the cost of rework must be borne by the other party. >>>More