-
In fact, it is the top column above the toilet seat to the water button below, you can pick up the water tank cover and adjust it.
-
This can be repaired by yourself, look at the structure of the toilet, and use your brains less; If the water pipe leaks, change the section. I really can't find someone to fix it, it's hard to say on this.
-
The drain was not closed.
-
Is the key at the top, if so, I guess the key lever is long, just make it shorter.
-
It must be the 0 vertical rods with the barbed that have touched the plane of the toilet lid, cut it shorter, and the lid will not leak if it can't be touched.
-
What does that toilet look like with your tank button on the top or side.
-
Pipe toilet sluice.
-
Maybe it's broken.
Solution 1: In fact, you can find a half-inch wide bamboo strip and put it into the toilet to dredge it to solve the problem. >>>More
Causes and solutions for toilet flushing weakness: blockage, water level of the inlet valve is too low, >>>More
This situation indicates that there is a blockage in the toilet, so that the water cannot be flushed down at once. >>>More
You can adjust the amount of water stored in the water storage tank appropriately, and raise the water supply valve float to increase the water storage capacity.
Open the toilet lid, turn up the water level switch in the water tank, make the key switch of the toilet lid longer, or stretch the spring inside, you can make the toilet flush suction better, try it yourself, it is really not good to call the shop that sells the toilet to send a master to get it down.