-
Anonymous users2024-01-24The first is to confirm whether there is an electric line on the ceiling or whether the installation is convenient, and the second is to measure the size of the panel lamp of the same size (a dao
Generally conventional). Third, open the gypsum board carefully, and act lightly. Connect the circuit. Seal the electric tape and start the switch to check whether the panel light is lit normally. Fourth, first tilt it into one side, put it all in, and then slowly push it flat. Good luck with your installation. Don't forget to bring a tester.
-
Anonymous users2024-01-23Is it a 61 by 61 gypsum board ceiling, just buy the matching one and put it in the frame.
This one is very simple, you can use latex.
First of all, there will be a keel in the plasterboard ceiling, and the general ceiling lamp is not particularly important, it is installed. >>>More
Install the aircraft plug first, and then install the lamp with screws, or replace the drywall, panel lamp replacement, 60 60 or other sizes, it is recommended that you go to the lighting store to turn around which to test.
If it is not too heavy, you can use the main keel boom to fix the chandelier, if the lamp is heavier, you must first install the hook on the top plate, and then hang the chandelier rod through the gypsum board on the hook.
The self-tapping screw is screwed on the keel, and the air gun is not firmly hit.