Can you still do sliding doors when the living room bricks are tiled?

It depends on whether you are ready to install a sliding door or a sliding door, if you want to install a sliding door, you need to stick the floor tiles first; If the sliding door is of course, the floor slide is installed and then the floor tiles are attached.

Sliding door installation steps:

1. The size of the track box on the upper part of the sliding door should be guaranteed to be 12 cm high and 9 cm wide. Like the curtain box, the track box is installed inside the track, and the sliding door can be hung on the track. When the height of the door is less than a meter, it feels oppressive.

Therefore, when making a sliding door, the height should be at least 195 + 12 = 207 cm or more.

2. The golden size of the normal door is about 80 cm to 200 cm, under this structure, the door is relatively stable, and at the same time it is also very beautiful. Therefore, the ratio of width to height of the sliding door should be similar to that of the golden size.

3. Be cautious of using the sliding door (open hanging track box) from the ground to the top. Due to the excessive swing amplitude when pushing and pulling, the sliding door is easy to deform after a long time, and the door cannot be opened after deformation, which means that it cannot be repaired and cannot be used.

4. When installing the sliding door track, fix the upper track, use the gravity cone (hanging wire hammer) to hang 3 points at both ends and the midpoint of the upper track, draw the point with a grease pen on the ground, install the upper track, and then put a hammer to the ground at the center point of the upper track, put the vertical line at both ends of the track, and fix the lower track at these 3 points, so as to ensure that the upper and lower tracks are completely parallel, and the push and pull of the sliding door is in the best state.

It can be pasted so that it is also convenient to slid the door measuring tape.