Where does the water seepage come from in the corner of the outside of the bathroom or at the door o

Updated on Bathroom 2024-08-12
4 answers
  1. Anonymous users2024-01-24

    Many people think that the waterproof layer will only leak downstairs if there is a problem, but in fact it is not the case, the waterproof layer is divided into a horizontal waterproof layer and a vertical waterproof layer on the side, the horizontal waterproof layer will leak to the downstairs if there is a problem, and the vertical waterproof layer on the side will leak to their own home if there is a problem. Water leaking into the corner of the outside of your bathroom or the door of the bathroom is first sure that the vertical waterproof layer on the side is broken somewhere, otherwise no matter how much water can only come up from the tile surface. In fact, the damp marks we see in the corner of the bathroom or the door of the bathroom are not vertically leaked in the past, theoretically speaking, as long as the waterproof layer is damaged somewhere, the open water in the bathroom penetrates below the tile surface from the corner, tile surface and joints or any other possible place, and is concentrated in the mortar layer, then the mortar layer is equivalent to becoming a water layer, and then concentrated in the waterproof layer where the damage leaks downstairs.

  2. Anonymous users2024-01-23

    See if there is a water pipe, generally there is water seeping out of the mortar layer under the bathroom tiles! , more information, better advice, free concrete waterproof leakage repair technical consultation, free of today, tomorrow leakage, annual repair, annual leakage trouble.

  3. Anonymous users2024-01-22

    If it is underfloor heating, please check the underfloor heating pressure, because sometimes the renovation will puncture the underfloor heating pipes.

  4. Anonymous users2024-01-21

    It should be that the early design of waterproof was not done well!

Related questions
2 answers2024-08-12

It should be minimized|A lot of water in the bathroom, and so on to the wall when the waterproof should be done in the bathroom, but you are afraid of the inside to do from the outside, you have to use glue to glue the kind of waterproof material that has fluff on both sides of the floor leather on the wall, and so dry first scrape once with 801 glue and good plain cement, and then scrape the putty on the exterior wall on the latex paint, because only in this way is equivalent to having an isolation layer.

2 answers2024-08-12

You are due to the bathroom wall waterproofing is not done, infiltrated in the past, first find someone to scrape off the wall skin can be scraped off, scrape white, and then take care of the bathroom, simple point can be used waterproof glue to repair the tile, to be stable to knock off the tile to make waterproof polypropylene, and then tiled.

5 answers2024-08-12

Piping problems. The most likely possibility is that there is a leak in the embedded pipe joint near the seepage point.

5 answers2024-08-12

Where does the water seepage come from in the corner of the outside of the bathroom or at the door of the bathroom? Which way should it be governed? >>>More

1 answers2024-08-12

Bathrooms are more susceptible to moisture.

Therefore, the door of the bathroom can not be made of wood, and the wall can be built with stone bricks, and the situation will be better. >>>More