-
Anonymous users2024-01-24All cold water pipes will be open, so it will go to the sink.
Don't worry about the problem of partial pressure, the probability of using it at the same time is very small, and the hot water pipe is generally divided into 4 pipes, and the cold water is divided into 6 pipes, even if the hot water is boiled and the cold water is turned on at the same time, it will not have much impact.
-
Anonymous users2024-01-23Generally, the sink is used, unless the customer makes a special request.
Hello! If the waterproofing of the bathroom has been done, that is to say, the bathroom is "wet" and can be bathed, then you can walk through the wall, go underground, and of course, go to the ceiling. >>>More
The height of the water heater interface is generally between 1.5 and 1.6 meters, and the distance between the hot and cold pipes should not be too wide. I hope my answer can help you.
There is no standard elevation for the water pipes, the duplex faucet is 1 meter from the ground, and the faucet connected to the water heater is 180 meters from the ground
It is best to use a small union of internal teeth, straight or curved, depending on the situation on site. The use of outer wires, direct or bent joints is an incorrect connection. The material of the pipe and pipe fittings should be matched, and the following plate is just an example of PPR. >>>More
The relationship is no, the same use, but the pipe is long, the reaction with hot water is slow, and the hot water in the pipe is wasted.